![]() ![]() Accelerate from a stop at the specified IPS specification while the transmission shifts through gears 1-2-3-4-5-6 and decelerate slowly to a stop. ![]() Drive the vehicle until the ATF temperature is within the range shown. Put your transmission into PARK or NEUTRAL and check it reads lower than 11 volts. ![]() Find your signal wire (black/white stripe or other color combination) on your TCM harness connector and connect your multimeter to this wire and ground it. Select Current Data and “Throttle Position.”Ħ. Locate the transmission control module and pull out or unplug it. Note: After the adaptive values have been reset (erased), an “adaptive learning” procedure must be completed.ĥ. Turn the ignition key off for 10 seconds. Relearn Adaptive Values: Note: After the adaptive values have been reset (erased), an adaptive learning procedure must be completed. Select Resetting Auto TIA values and follow the screen prompts. Select “Resetting Auto TIA values” and follow the screen prompts. From the main screen, select Option Treatment. Wait for 1-2 minutes without touching any of the vehicles controls. From the main screen, select “Option Treatment.”ģ. So, how do you reset a transmission control module Follow these steps to reset the TCM. Attach a GDS and select VIN and A/T menu. Reset PCM/TCM Adaptive Values with GDS:ġ. Reprogram or exchange a PCM/TCM from another vehicle. Wait for additional 20 seconds, turn the car off, and quickly turn it back on. To complete the Transmission Service Fast Learn procedure, enter GDS2 Diagnosis and navigate to: Module diagnostics Transmission Control Module Configuration / Reset Function Transmission Service Fast Learn Transmission Service Fast Learn is the recommended method to reset and relearn adapts. Reset automatic transmission on Mercedes / Reset adaptation Gearbox 722. Turn off the ignition and wait for 20 seconds at least, put the car in park mode. Your body control module also controls the power windows, air conditioning. Start by replacing the fluids, so your transmission can adapt to the newer fluid properties. With the Transmission Control Module reset, its time to reconnect your battery and take your Ford F150 for a test drive. This bulletin provides the procedures necessary to reset (erase) and “relearn” the PCM/TCM adaptive values.Īfter the following repairs have been completed, the PCM/TCM adaptive values must be reset in order to provide optimum shift quality: Listed below are some of the steps needed to reset your ford transmission control module. The PCM or TCM contains logic to adjust solenoid duty and line pressure as needed to compensate for normal clutch wear over the life of the transaxle. Caution: After replacing a transaxle or reprogramming the PCM/TCM, to improve the shift quality condition, follow this procedure to reset and relearn the adaptive learning. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |